Configuring cameras using IPCam
We have found these steps are helpful for customers looking to setup their cameras in both wired and wireless mode. Any comments or suggestions please let us know!
1. Connect the camera using supplied RJ45 lead to the ethernet port of the PC.
2. When connected, ensure that the local area network lights up, and
there is no “limited connection message”.
3. Run IPCamSetup.
4. Click “Find IP Cam”
5. When the camera appears in the list highlight it and then in the
section below enter the IP address 192.168.2.101 (first check your IP
settings in windows by running ipconfig from the command prompt - make
sure the IP range matches your LAN adapter, NOT the wireless adapter.
As long as the first 3 sets of numbers match those in your LAN adapter
and the last number is between 100-200, you should be OK.)
6. Click “Setting”
7. Click “Find IP Cam” again
8. Highlight the camera in the list, and check that the new IP address
has been displayed.
9. Click “Show IP Cam” and the browser should launch and the login page appear.
10. Enter the default username and password.
11. You can configure the wireless configuration by entering your
network SSID and network key by clicking “Scan access point”
12. Highlight your wireless network from the list
13. Enter your network SSID (network name)
14. Choose the encryption type you are using (if any)
15. Enter the network key in “Key”
16. Click “submit”
17. Then click the radio button “Wireless” and click “setting” again.
18. Change the switch on the camera to WLAN and press the “reset” button
19. When the camera has powered up choose your wireless network
adapter from the drop down list and then Click “Find IP Cam”
20. The camera should appear in the list.
21. Disconnect the RJ 45 cable.
21. Click “Show IP Cam” and it should launch in wireless mode.