Bytemart

Unpack the S-W-PL Grandtec WiFi Camera Plus

Setup the connections to the camera

1. Screw together the stand and screw the camera into the stand and sit the camera on the desk
2. Check the switch on the side of the camera is set to RJ45
3. Plug in the supplied network crossover cable from the RJ45 socket on your computer to the RJ45 socket on the camera
4. Connect the power supply
5. Check that the green light illuminates on the front of the camera

Insert the supplied CD - IP / WIFI Camera Plus - V6.4 - Model 2  Follow the instructions in this post:- Install IP Auto Detect Tool

Launch the IPCam Setup application and configure the network settings of the camera

1. Choose the adapter connected to the camera
2. Click Find IP Cam and hopefully a MAC address and other information should appear in the IP Cam List
3. Setting the camera with the following settings:-
   Wireless
   Manual
   IP Address: 192.168.0.100
   Net Mask: 255.255.255.0
   Gateway: 192.168.0.1
4. Click Setting
5. Click OK
6. Click Scan Access Point
7. This will search for all local wireless networks
8. Choose your Wireless network from the list and choose the correct settings (these settings will differ depending on your network configuration)
   SSID: Wireless
   Wireless opmode: Infrastructure
   Encryption Type: WEP (10 HEX)
   KEY: ******************
9. Click Submit
10. Click OK
11. Change the switch on the side of the camera to Wireless
12. Press RESET on the camera with a small screwdriver
13. Click Show IP Cam

If all went well, Internet Explorer will launch and you will be presented with a login box, the default username and password is:

1. Username: root
2. Password: admin
3. Click your chosen language
4. You will now see a streaming video picture

Congratulations, your camera is now ready for permanent installation.